Sena HelloDevice UniversalComm Manuel d'utilisateur

1 HelloDevice UniversalComm Users Guide Version 1.0.0 2003-09-25

10 1) [Load] button Used in opening the file to transfer. 2) [Save] button Used in storing the user input data to file. 3) [Clear] button Used in

115. Test operation Using the HelloDevice UniversalComm (user PC) and the HelloDevice, users can test the communication between PC and the HelloDevic

125.2. Configuration - IP address of User PC: 192.168.18.10 - HelloDevice Configuration ! IP address: 192.168.18.1. ! Host mode: 1320, LS100,

135.3. Operation 5.3.1. Data transfer by TCP communication 1) Enter the data stream, “0123456789abcdef” in the Sending Data frame under the program

2 Table of Contents 1. Overview...

31. Overview HelloDevice UniversalComm is a program that enables the users to flexibly send/receive data through TCP or UDP or Serial RS232 connectio

42. Installation 1) Run the setup program, Setup_HDUniversalComm_1.0.0.exe. 2) Proceed to the installation process according to the guide. 3) If

53. Configuration of the communication mode The Server Setting frame is composed of the following sections. - Communication mode set-up section - C

6 UDP [Bind] or [Stop Bind] RS232 [Open] or [Close] 3.2 TCP Server mode setting 1) Enter the Listening TCP port number into the Server Port f

73.4 UDP Server mode setting 1) Enter the UDP server port number into the Server Port field, and enable the UDP Server/Client check box. 2) Pres

82) Enable the UDP Server/ Client check box. 3) Press [Bind] button, and then UDP tunneling session is created. 3.7 RS-232 serial mode setting

94. Data Communication If users perform the session creation command such as Listen, Connect, Bind and Open after they configure the communication mo