Sena STS Series Guide de l'utilisateur télécharger pdf (Page 51)

4.2.5. Remote Host Configuration

Remote host configuration is the list of hosts that will receive data from serial port of STS Series when

there is data transmission from a serial port of STS Series.

In TCP mode, user can also configure secondary remote host that will receive data from serial port if

STS Series fails to connect to primary remote host. But if connection to primary remote host can be

made, STS Series dose not send data to secondary remote host until connection to primary remote

host failed. And the maximum possible number of primary remote host is limited up to 16.

In UDP mode, user can configure only primary remote host because there is no way for STS Series to

check status of primary remote host, so secondary remote host is meaningless.

Figure 4-8 shows Remote host configuration pages of the Web UI. (TCP mode)

Figure 4-8 Remote host configuration

4.2.6. Port IP Filtering Configuration

The remote hosts that are allowed to access the STS Series serial ports can be specified based on the

IP address filtering rules. The user may allow specific hosts to access the STS Series serial ports by

providing a valid IP address or network address and its subnet mask. Please refer to section 3.5. IP

Filtering for more details.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 130 131

Pas de commentaire

Sena STS Series Guide de l'utilisateur Page 51